Hi all new here. CFWA ISSUE'S

Post Reply
gqracingsolutions
Enlisted
Posts: 1
Registered for: 4 years 8 months

Hi all new here. CFWA ISSUE'S

Post by gqracingsolutions »

Hi

Ok so I have a 2013 SEAT IBIZA 1.2TDI CFWA, it's never actually run right in all the time we've had it. I had it flashed and bored out tge dpf and turned off the egr. When I collected it he said the NK valve may be faulty because it wasn't producing the correct vacuum boost for the turbo.
I replacd the valve and it still had the fault coming up then I replaced the vacuum pump with a very low mileage one. I could see the wear on the original one. Still no difference.
The fault says implausible position for the turbo actuator.
I would like to ask if anyone has a diagram of where the vacuum pipes run. I think they msy have been off at some point before I got tge car.
Many thaks
GQ
User avatar
panic-mechanic
Panic's Place
Posts: 26715
Registered for: 21 years 7 months
Membership No: 79
Location: Benoni, putfontein.

Re: Hi all new here. CFWA ISSUE'S

Post by panic-mechanic »

It Could also be the actuator that is faulty or the mechanicla bits on thenturbo that is stuck
Stephan van Tonder - Jhb - Putfontein Benoni
'05 Audi A6 3.0L TDI Avant
'09 Touareg 3l TDI
'13 VW CC 2l tdi (repair project)
'05 Touareg v10

Perfect Power dealer. I do dyno tuning.
Post Reply