Solid (single mass) flywheel on AAL 16v motor
-
- Enlisted
- Posts: 3
- Registered for: 6 years
Solid (single mass) flywheel on AAL 16v motor
Hi guys, which solid flywheel (210mm) will bolt up to a AAL 16 VALVE crankshaft? I appreciate your inputs.
- PapaJo
- Brigadier
- Posts: 6994
- Registered for: 14 years
- Car Make: VW's
- Car Model: '16 7R, '86 Caddy AUM 20VT
- Membership No: missing
- Location: Meyerton or Offshore Guyana.
Re: Solid (single mass) flywheel on AAL 16v motor
Which gearbox will be used?
- panic-mechanic
- Panic's Place
- Posts: 26715
- Registered for: 21 years 8 months
- Membership No: 79
- Location: Benoni, putfontein.
Re: Solid (single mass) flywheel on AAL 16v motor
The one from a cti. As a matter of fact all the 4cylinder engines of that era up to where they went to tfsi has the same bolt pattern.
Stephan van Tonder - Jhb - Putfontein Benoni
'05 Audi A6 3.0L TDI Avant
'09 Touareg 3l TDI
'13 VW CC 2l tdi (repair project)
'05 Touareg v10
Perfect Power dealer. I do dyno tuning.
'05 Audi A6 3.0L TDI Avant
'09 Touareg 3l TDI
'13 VW CC 2l tdi (repair project)
'05 Touareg v10
Perfect Power dealer. I do dyno tuning.
-
- Enlisted
- Posts: 3
- Registered for: 6 years
Re: Solid (single mass) flywheel on AAL 16v motor
Thanks Papajo and Panic mechanic. This motor (turbo I hope) will find it"s way into a Porsche 924. Will be using a 020 bellhousing(cut off from rest of gearbox) with concentric clutch and special made clutchplate to fit the spline count of the 924 torque tube.