Howsit Guys
I have just done the engine on my vehicle
Did the complete block and head cylinder
The timing is perfect set on relevant marks the rear main seal is also set right
But the car idle seems to fluctuate and cuts off at certain times
Ran a diagnostic on the vehicle gives the error of cam shaft sensor
my question is before buying a camshaft sensor is these problems in line with the symptoms of a cam shaft sensor ?
Thanks
vw polo 9n bah
-
- Enlisted
- Posts: 5
- Registered for: 6 years 5 months
- Car Make: VW
- Car Model: POLO 9N
- panic-mechanic
- Panic's Place
- Posts: 26715
- Registered for: 21 years 8 months
- Membership No: 79
- Location: Benoni, putfontein.
Re: vw polo 9n bah
You need to give the exact error. IE does it say the camshaft sensor is dead - ie open circuit or short to grounfd or short to plus OR does it say camshaft correlation error.
Stephan van Tonder - Jhb - Putfontein Benoni
'05 Audi A6 3.0L TDI Avant
'09 Touareg 3l TDI
'13 VW CC 2l tdi (repair project)
'05 Touareg v10
Perfect Power dealer. I do dyno tuning.
'05 Audi A6 3.0L TDI Avant
'09 Touareg 3l TDI
'13 VW CC 2l tdi (repair project)
'05 Touareg v10
Perfect Power dealer. I do dyno tuning.
-
- Cadet
- Posts: 121
- Registered for: 11 years 6 months
- Car Make: Vw golf
- Car Model: Citi golf 2.0L 8V
Re: vw polo 9n bah
Hi I’m sitting with the same problem exactly the same problem ,error code it give “P0343 -camshaft position sensor A circuit high bank 1 or single sensor” that’s what it shows on my OBII reader and the car was fine wen it came in redid the whole
Motor with rear main crank seal
Motor with rear main crank seal
-
- Cadet
- Posts: 121
- Registered for: 11 years 6 months
- Car Make: Vw golf
- Car Model: Citi golf 2.0L 8V